Firstly, before starting up, it is necessary to drain the remaining sewage.

Secondly, moisten the warp threads at the weaving mouth, steel reeds, and heald with water to soften the remaining accumulated slurry and prevent the remaining hard slurry from roughening or breaking the warp threads during direct driving.

Thirdly, connect the power supply, plug in the circuit control board, open the water supply valve of the water tank, test the power and water supply, and observe whether the water and electricity are normal.

Fourthly, if it is necessary to change the variety and specifications of the raw silk, the weft yarn and appropriate feeding and coiling gears can be replaced to change the weft density.

Fifth, if there is severe shedding of pulp at the wire harness of the steel reed, resulting in warp fuzzing, etc., the warp can be manually shaken a few centimeters to more than ten centimeters through the weaving mouth. Depending on the specific situation, try driving again.